A dirty, burnt, contaminated, or loose wire will interfere with the sensor signals. Gently pull on the wires to check for tightness. Visually inspect the electrical connector and terminal for dirt or damage. So even if you don't have this information at hand, go ahead with the tests anyway. Sometimes, you can identify these wires by testing them as described later. Check your repair manual, ask at your local auto parts store, or search online for this information. Identify the power, ground(s), and signal wires on the electrical connector.If you use the latter method, wrap the pierced wires with electrical tape when you're done with the tests, to prevent rust from creeping into the wires. If not, you'll need to pierce the wires using a pin when conducting your tests. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |